Gallagher T15 Mifare Reader Black 설치 참고 사항 - 페이지 9
{카테고리_이름} Gallagher T15 Mifare Reader Black에 대한 설치 참고 사항을 온라인으로 검색하거나 PDF를 다운로드하세요. Gallagher T15 Mifare Reader Black 13 페이지.
Gallagher T15 Mifare Reader Black에 대해서도 마찬가지입니다: 사용자 지정 설치 참고 사항 (13 페이지)
페이지 인쇄
A Cardax IV Reader connects to a Gallagher Controller 6000, Gallagher 4R/8R Module (attached
to a Controller 6000), Gallagher GBUS Universal Reader Interface (Gallagher GBUS URI), Gallagher
Controller 3000-8R or 3000-4R, Gallagher Local Bus Universal Reader Interface (Gallagher URI) or
a Gallagher Local Bus Reader I/O Interface.
HBUS Reader connection:
Note: To terminate an HBUS Reader, connect the Orange (HBUS Termination) wire to the Green
(HBUS A) wire.
Cardax IV Reader connection:
5.
Fit the facia assembly into the base by clipping the small lip, into the top of the base and holding
the top, press the bottom of the facia assembly down into the base.
6.
Insert the M3 Torx Post Security screw (using a T10 Torx Post Security screwdriver) through the
hole at the bottom of the base to secure the facia assembly.
Note: The Torx Post Security screw needs only to be lightly tightened.
3E4237 Gallagher T15 Reader | Edition 1 | June 2016
Copyright © Gallagher Group Limited
Positive
Red
Negative
Black
HBUS Termination Orange
HBUS A
Green
HBUS B
Brown
CDXIV TX
White
CDXIV RX
Blue
Positive
Red
Negative
Black
HBUS Termination Orange
HBUS A
Green
HBUS B
Brown
CDXIV TX
White
CDXIV RX
Blue
Reader tail
Facia
Fit screw to secure facia to base
HBUS Reader terminated:
Positive
Negative
HBUS Termination Orange
HBUS A
HBUS B
CDXIV TX
CDXIV RX
Building cable
Connection
Red
Black
Green
Brown
White
Blue
Page 9