Galleon SignalClock Series 설치 및 사용자 설명서 - 페이지 17
{카테고리_이름} Galleon SignalClock Series에 대한 설치 및 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Galleon SignalClock Series 19 페이지.
페이지 인쇄QUICK SETUP GUIDE
1. Connect the clock via Ethernet to either a PoE enabled switch or a power injector.
2. By default, the clock will have DHCP enabled. If a DHCP server is unavailable, the clock will
assign itself the IP address: 169.254.0.1. Once the clock has an IP address, it will display it
on the clock face. Take note of the IP address.
3. Using a web browser, navigate to http:// followed by the IP address of the clock.
4. At the log in screen, type the default password: admin.
5. After successfully logging in, you will be redirected to the Home page. Navigate to the
Network Settings page if you wish to configure static network settings. Select STATIC and
type in the network settings. Now, click Apply Changes.
6. Navigate to the Time Server Address page and type in the IP address of the time server.
Click Apply Changes.
7. Navigate to the Display Format page, choose the appropriate format and click Apply
Changes.
8. Navigate to the Time Zone Settings page and configure the appropriate offset to UTC. Click
Apply Changes.
9. If applicable, navigate to the Daylight Saving Time page and configure the appropriate
settings. Ensure DST is enabled and click Apply Changes.
10. Navigate to the Change Password page and change the web interface password (default
password is admin). Click Apply Changes.
11. Click Reboot Clock to apply the configured changes.
www.galsys.co.uk
galleonsupport.com
SIGNALCLOCK V2 Manual
17
TEL:
+44 (0) 121 608 4433
FAX:
+44 (0) 121 608 4477