Galleon SignalClock Series 설치 및 사용자 설명서 - 페이지 5

{카테고리_이름} Galleon SignalClock Series에 대한 설치 및 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Galleon SignalClock Series 19 페이지.

If your network does not have a PoE enabled network switch, you will need to use a power

injector with the clock. A power injector passes Ethernet communications through while also

injecting power in accordance with the IEEE 802.3af standard.

The above diagram shows how a power injector fits into the set up. If you have a power injector

supplied by Galleon, connect the hub/switch to the port labelled "LAN" on the power injector and

connect the clock to the port labelled "PoE" on the power injector. Plug the power supply in and

wait for the clock's display to come on. When the unit powers up, make a note of the IP address,

as this will be needed to configure the unit via the web interface.

2. DHCP SERVER

By default, the SignalClock is set to use DHCP to obtain its IP Address. If the clock is unable to

receive network settings from the DHCP server, the clock will cycle: '----'. If the clock is unable to

obtain an IP address after several attempts, it will set its IP address to 169.254.0.1. This is done so

that the unit can be configured without requiring a DHCP server.

Once the unit has obtained an IP address from a DHCP server on your network, configuration (such

as static network settings) can be applied to the clock. For help with this, please see the "Web

Configuration" section of this manual.

www.galsys.co.uk

galleonsupport.com

SIGNALCLOCK V2 Manual

TEL:

+44 (0) 121 608 4433

FAX:

+44 (0) 121 608 4477