AFINIA LABEL L901 빠른 시작 매뉴얼 - 페이지 5

{카테고리_이름} AFINIA LABEL L901에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AFINIA LABEL L901 7 페이지.

페이지 인쇄

8. Connect Device Now.

Turn Printer ON:

1. Press Main Power Switch on Rear Panel.

2. Press Power Button on Control Panel.

Connect USB cable. Do not click either

button. Software will finish installing.

9. Finished software installation.

You can check "Set this printer as the default

printer" at this time. Click "Finish".

10. Close Installer.

11. Restart computer to complete installation.

Step 5

Install Ink Tanks

Printer uses (1) Printhead and (5) Ink Tanks (two Black,

one Cyan, one Magenta, and one Yellow).

1. Look at the Control Panel

Touchscreen. Ink Tank status

information appears in right

side of the Touchscreen. Note

that the Ink Tank indicator

boxes are empty.

NOTE: The question marks

indicate that no Ink Tanks are

detected by the Printer.

2. Open the Ink Tank Door (hinged at bottom).

(Disconnects Printer communication with Ink

Tanks and allows safe installation and

replacement) Open Ink Tank Latches [A].

3. Remove new Ink Tank(s) from packaging.

4. Insert Ink Tanks (labels up) into appropriate

color slots [B]. Close Ink Tank Latches.

INSTALLATION TIP: Make sure Ink Tanks

seat properly. Insert Ink Tank into

appropriate Ink Station, then pull Ink Tank

back about an inch and push forward firmly

to insure that Ink Nozzles penetrate seals on

Ink Tanks.

5. Close Ink Tank Door. Ink colors

fill in as Ink Tanks are installed. If

ink colors do not fill in after a few

seconds, open Ink Tank Door

again and reinstall Ink Tank(s).

INK IN INK TANKS MAY BE HARMFUL IF

SWALLOWED. KEEP NEW AND USED INK

TANKS OUT OF REACH OF CHILDREN. DISCARD

EMPTY INK TANKS IMMEDIATELY.

Page 5

WARNING!