DCS EH-36SS 사용 및 설치 매뉴얼 - 페이지 13
{카테고리_이름} DCS EH-36SS에 대한 사용 및 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DCS EH-36SS 18 페이지. The professional euro vent hood
DCS EH-36SS에 대해서도 마찬가지입니다: 사용 및 관리 매뉴얼 (11 페이지), 사용 및 관리 매뉴얼 (7 페이지), 설치 매뉴얼 (14 페이지), 설치 매뉴얼 (16 페이지)
페이지 인쇄
Use & Care In formation
CONTROL PANEL
The control panel is located on the right-hand side under the canopy.
LIGHT ON/OFF SWITCH ( A )
On/Off switch for the halogen light. Move the switch to "1" to turn the light ON and to "0" to turn it
OFF.
BLOWER ON/OFF SWITCH ( B )
On/Off switch for the blower. Move the switch to "1" to turn the blower ON and to "0" to turn it
OFF.
BLOWER SPEED SWITCH ( C )
Speed control for blower. Move the switch to position 1 for LOW Speed, 2 for MEDIUM speed and 3
for HIGH speed.
For Best Results Start the euro hood before cooking and allow the unit to operate for several minutes
after cooking is complete to clear all smoke and odors from the kitchen.
CLEANING
The metal grease filters should be cleaned frequently in hot detergent solution or washed in the
dishwasher. Clean exterior surfaces with a commercially available stainless steel cleaner. Abrasives and
scouring agents can scratch stainless steel finishes and should not be used to clean finished surfaces.
REPLACING THE HALOGEN LAMPS
WARNING: Before you begin, make sure that the euro hood is
turned off and that the other lamps have had
sufficient time to cool. Halogen bulbs burn extremely
hot and serious injury could result from touching a hot
bulb.
To replace the lamp, the bezel (A) around the lamp(C) must be
removed. The bezel (A) is held in place by two screws (B). Remove
the two screws and the bezel.Then remove the lamp and replace with
a new lamp. Once the new lamp is in place, reinstall the bezel.
NOTE: This euro hood uses 20 watt Halogen Lamps.