DCS Vent Hood ES36 설치 매뉴얼 - 페이지 15
{카테고리_이름} DCS Vent Hood ES36에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DCS Vent Hood ES36 20 페이지. The professional and euro vent hood
DCS Vent Hood ES36에 대해서도 마찬가지입니다: 사용 및 관리 매뉴얼 (13 페이지)
페이지 인쇄
CABINET INSTALLATION
1.
Find the centerline of the cabinet bottom. Draw a line along this centerline from rear to front of
the cabinet.
2.
Refer to the top of the hood and Fig. 8. Draw two lines, one at distance 'K' from the wall, the other
one at distance 'Z' from the previous line. NOTE: These lines must be perpendicular to the cabinet
centerline. Mark 4 points , two along each line at a distance of half W from the center line, to
determine the screw locations.
3.
Fit four #10 pan head wood screws on cabinet bottom. Do not tighten completely but leave a
space of about 1/2" from cabinet bottom surface and screw heads.
4.
Hang the hood on screws through side slots provided on hood top. Tighten the four screws.
Drill a 3/8" hole through the center of the holes K into the wall. Insert two wall plugs into drilled
holes. Tighten hood to wall anchors by installing 2 screws with washers.
5.
Attach duct to transition with screws and seal with duct tape. Screws must not hamper the
damper.
ES SERIES
K
Z
ES30
2-11/16"
6-7/8"
ES36
2-11/16"
6-7/8"
VS SERIES
K
Z
VS30
2-5/8" 7-1/16" 29-1/16"
VS36/VS1236 2-5/8" 7-1/16" 35-1/16"
VS48
2-5/8" 7-1/16" 47-1/16"
W
29-1/16"
35-1/16"
W
Knockouts
(junction box)
14
INSTALLATION
Side slot for cabinet
bottom mounting
Z
W
K
Transition with
Backdraft (Top outlet)
w w
W
C/L
CL
Screw for cabinet bottom
installation
FIG. 8
Z
K