Dynatronics Hausmann 6175 설치 및 작동 지침 - 페이지 3

{카테고리_이름} Dynatronics Hausmann 6175에 대한 설치 및 작동 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Dynatronics Hausmann 6175 6 페이지. Stand-in table

6. The harness length can be adjusted as required by use of the buckles and straps located on each side of the

harness. The buckle strap must be looped through the buckle to be properly secured.

7. Ensure the patient's toes are to the toe plate and knees are on the knee pad.

8. Using the hand-held control, activate the motor drives to raise the patient from sitting to a standing position.

9. Once the full upright standing position is reached, adjust the chest pad to desired height, then lock the back

support into position. You may now also adjust the height of the table using the hand-held control.

10. To lower the patient back to the wheelchair, reverse the procedure.

E. Cleaning and Disinfecting Surfaces

1. Unplug the power cord before cleaning or disinfecting.

2. Periodically wipe the table off with a damp cloth or with mild soap and water.

3. Disinfect the table top by scrubbing with an approved germicidal solution. After scrubbing, rinse with a wet

cloth and allow to dry.

4. Ensure your hands are dry and the power cord and plug assembly are dry when reconnecting the power cord.

F. Maintenance

Perform the following actions periodically to maintain the product.

1. Wipe table off with damp cloth or mild soap and water to maintain finish.

2. Inspect the power cord and plug for frayed wires and/or damaged insulation.

3. The joints use oil impregnated bronze bushings and should not require lubrication.

IU-6175 Rev 2

Page 3 of 6