Dynaudio Acoustics BM 5A 사용자 설명서 - 페이지 8

{카테고리_이름} Dynaudio Acoustics BM 5A에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dynaudio Acoustics BM 5A 11 페이지. Two-way active nearfield monitor
Dynaudio Acoustics BM 5A에 대해서도 마찬가지입니다: 사용자 설명서 (11 페이지), 사용자 설명서 (12 페이지), 사용자 설명서 (11 페이지)

페이지 인쇄

1/2. Power On/Off switch/AC Power In

Before switching on, make sure Mains boltage

matches your areas Mains boltage specification.

Replace fuse only with the fuse-type marked on

the rear-panel label.

3. Balanced analog Input

Mudio Input is via a female cLR connector. The

Input is electronically balanced with following

connections. The connections are printed on

the rear for easy reference.

If your signal source is unbalanced, usually the

unused pin is connected to ground. This is

normally done inside the connecting cable.

Special adaptors Hnot suppliedI can be bought

that converts Slr input to single ended RCM type

input. For best result use only good Yuality

screened cables and connectors.

Switches

Tn the rear of the monitor you will find 5

switches for setting up the monitor for optimum

performance in different acoustic environments.

Each switch is eSplained in the following.

4. High Pass filter switch

This switch sets the lower cut-off freYuency of

the monitor. It is used to match the monitor to a

subwoofer. \ou can select between 605K or

805K c-over. Flat is used in case you do not

use a subwoofer to assist your monitors. When

used with a subwoofer it is recommended to

use either 605K or 805K filter, thus allowing a

higher undistorted soundpressure level.

SETTING UP

5. Level trim

Vse this switch to match the sensitivity of the

BM 5M monitor to your source.

5igh-output source

If your source has a high Tutput, set the switch

to the -10 position to reduce the sensitivity by

10dB.

Low-output source

If your source has low output, set to e4 position

to gain 4dB more sensitivity.

6. LF

This switch controls the bass gain level using

shelf-type EQ. The level can be set to e2dB,

0dB or -2dB.

This filter is used to adjust for the proSimity of

boundaries, so if positioned close to wall or

corner, use the -2dB setting. If positioned far

from walls use the e2dB or 0 position,

depending on other eYuipment, and personal

taste.

7. MF

This switch sets a notch filter, used to

compensate for the acoustic effect of a console.

Such placement usually results in a response

peak in lower midrange. The MF switch

activates a bell shaped notch filter, which can

compensate. Vse either the -2 or the -4dB

setting. \ou may eSperiment finding the setting,

which provides the flattest response.

8. HF

This switch controls the Treble level and it is

used to match the high end of the monitor to

your other electronic eYuipment, and your

acoustical environment. Vse the setting

providing the preferred timbre. If the sound is

too brightg try to set to -1dB to reduce treble by

1dB. If too dull sound, use e1dB setting to raise

the treble by 1dB.