Dynaudio BM 6A mkII 사용자 설명서 - 페이지 9

{카테고리_이름} Dynaudio BM 6A mkII에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dynaudio BM 6A mkII 15 페이지. Monitor system
Dynaudio BM 6A mkII에 대해서도 마찬가지입니다: 소유자 매뉴얼 (7 페이지), 사용자 설명서 (12 페이지)

페이지 인쇄

Miscellaneous

Troubleshooting

If the speaker stops working and the power LED turns red (fault condition) switch the mains power off and leave it

for a moment. If the unit fails to operate again when you switch back on the fault may be due to overheating,

switch off again and allow it to fully cool down before powering up. Ensure the heatsink is clear of obstruction and

has free air circulation around it. If however the fault condition persists the unit should be inspected by qualified

personnel.

If the speaker stops working and no LEDs are alight then the mains fuse on the back panel should be checked

and replaced if necessary. If this does not rectify the problem the unit should be inspected by qualified personnel.

Care

Components of the highest quality are used in the BM6A and should ensure a long trouble-free life. Here are a

few hints to help them on their way.

Avoid running the system into clipping or distortion. When an amplifier clips it can send potentially damaging DC

components to the drive units. They may not fail at once but prolonged exposure to this will result in eventual

failure.

If you need to switch off or unplug equipment connected to the monitor, turn off the monitor first. Large voltage

spikes are often generated when equipment is switched off which will be amplified to a potentially damaging level.

Do not touch the drive units. The tweeter especially uses a very fine fabric diaphragm which is easily damaged.

Miscellaneous