adept technology Cobra 03352-000 설치 절차 매뉴얼 - 페이지 5

{카테고리_이름} adept technology Cobra 03352-000에 대한 설치 절차 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. adept technology Cobra 03352-000 8 페이지. S-series; i-series; plc-series

페이지 인쇄

Figure 2. Solenoid Placement Using Mounting Hardware

9. Install the appropriate lengths of 5/32 inch plastic tubing (supplied) into the two

output ports on the manifold.

10. Route the tubing up along the tower bracket next to the quill and down through

the center of the quill.

Use cable ties, as needed, to secure the tubing.

11. For non-inverted robots, remove the four screws from the Joint 1 cover (see

Figure

3); for inverted robots, remove the four screws from the User Connector

Panel (see

Figure

4). Remove the cover enough so you have access to the tubing.

Figure 3. Connecting Spare Air Line to User Connector

Adept Cobra s600/s800 Robot Solenoid Kit Installation Procedure, Rev B

Robot Solenoid Kit Installation Procedure

Air intake

coupling with

spare air line

Tubing connected

to output port

Mounting screws for

solenoid assembly

Joint 1 cover

lifted to access

spare air line

User Air fitting for

connecting spare

line. Remove

factory installed

tubing first.

Tubing bundle

containing spare

air line