Dynaudio 9S 소유자 매뉴얼 - 페이지 11
{카테고리_이름} Dynaudio 9S에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dynaudio 9S 18 페이지. Precision bass, optimised for the studio
페이지 인쇄
Operation
20
RIGHT
POWER
LFE / Slave IN
3.
ON
AUTO
SUB I/O
4.
SAT Highpass
LFE
Slave
Flat
60Hz
80Hz
50Hz
ON
SAT/SUB Input
2.
LEFT
OFF
RIGHT
Switching the subwoofer on
LFE / Slave IN
Once you have ensured yourself that
Power modes
SUB I/O
all necessary connections have been
•
On: the subwoofer is switched on
made, the subwoofer and the connected
permanently
components can be switched on.
•
Auto: when a music signal is
LFE
Slave
detected, the internal amplifier is
1.
Connect the subwoofer to the mains
activated automatically. The status
power.
LED on the back of the subwoofer
2.
Switch the subwoofer on with the
will light up green. As long as a
ON
main POWER switch on the rear
music signal is available on the
panel.
subwoofer's input, it will remain
3.
The status LED on the rear of the
switched on.
subwoofer will light up red.
•
After 15 to 20 minutes of not
OFF
4.
Select a power mode with the Power
sensing any input music signal,
switch on the rear panel.
the subwoofer will switch itself
to Standby mode automatically.
The status LED on the back of the
subwoofer will light up red.
GAIN
PHASE
OUT
0° 180°
To Slave
Min
Max
SUB Lowpass
150Hz
~ 50/60Hz 3.15A
SAT Output
1.
FUSE T3.15A L 250V
OUT
To Slave
Note
To switch the subwoofer
completely off, set the main
POWER switch to the OFF position.
~ 50/60Hz 3.15A
FUSE T3.15A L 250V
Operation
21