DCS LDT-M1 사용자 설명서 - 페이지 8

{카테고리_이름} DCS LDT-M1에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DCS LDT-M1 15 페이지.

Mount a new lens to the camera. On the LDT-M1 press the calibrate button. On the WCU-4

Choose: MENU > LENS DATA > LENS PROGRAMMING > CREATE LENS FILE.

Select the lens brand, it can either be selected from a list or added manually. Use the up and

down buttons to select from the list, or select custom to enter a custom lens brand name. Press

OK or the user button to confirm the selection.

To enter a custom brand lens use the zoom stick to select characters on the left hand side of

the screen. In order to select a character press the user button. In order to delete a character

press the delete button. When finished press the OK button to select the lens type.

To select a focal length use the up and down buttons or the zoom stick to navigate the list. In

order to enter a custom focal length press custom. For a zoom lens select zoom and then press

OK or user button to confirm.

To enter the lens serial number use the zoom stick to highlight a number and press the user

button to select it. Press the delete button to delete the last number. Press the OK button once

the serial number is complete.

Select the unit of measurement for focus, use the up and down buttons or the zoom stick to

select metric or imperial and then press the OK or User button to confirm.

Mapping a Lens Table

Once all the lens information is entered, select either 'Focus', 'Iris' or ''Zoom' (if a Zoom

lens is being used) axis to start mapping the lens.

Mapping The Focus Axis

Use the focus knob to move through the span of the axis, ensuring that it reaches each

end of the lens. If not, check if there were any slips during calibration.

To programme the focus scale press the focus button.

To set the infinity mark for focus rotate the focus knob until the lens reaches infinity. Press the

OK or user button to set the infinity point.

To set the close focus mark. Rotate the focus knob until the lens reaches closed focus. Use the

up and down buttons or zoom stick until the close focus value appears on the screen. Press the

LDT- M1 User Manual