DCS DishDrawer DD24SVT7 설치 지침 매뉴얼 - 페이지 5
{카테고리_이름} DCS DishDrawer DD24SVT7에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DCS DishDrawer DD24SVT7 16 페이지. Dishdrawer
페이지 인쇄REMOVE THE DRAWER
3a
1
Product may move.
Mark chassis position
on cavity
2
3
TERMINATE THE WIRING AS SHOWN
3c
Remove knock-out for cable clamp and
fit a suitable cable clamp for the conduit.
11
12
Use copper conductors only.
OPTIONALLY HARD WIRING PRIOR TO INSTALLATION
3
4
3
To prevent kinked hoses, we recommend
rotating the drawer counter-clockwise
5
and resting it on its side after removal.
Press the release tabs in on
either side and push back
to release drawer from
runners.
11
10
9
REMOVE THE ACCESS COVER & POWER CORD
3b
4
Access
6
cover
WARNING!
Electrical Shock Hazard
Before continuing, ensure that the product is
disconnected from the power supply.
Failure to follow this warning may result in
electrical shock, injury or fire.
REFIT THE DRAWER ONTO THE RUNNERS & CLOSE
3d
17
19
Ensure the release tabs on
both sides are reset fully.
5
7
Ensure the drawer
is now rotated
clockwise back.
16
18
13
15
14
16
5
8
8
7
15
17
Before refitting the drawer,
ensure the hoses are not
twisted and the latches at
the rear of each drawer
runner are facing forward.