DCS DishDrawer DS224 Series 설치 지침 매뉴얼 - 페이지 5
{카테고리_이름} DCS DishDrawer DS224 Series에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DCS DishDrawer DS224 Series 13 페이지. Double and single dishwashers
페이지 인쇄SINGLE MODELS
SERVICES SPECIFICATIONS
WATER CONNECTION
Recommended HOT
(Maximum 140°F/60°C).
Supplied hose to suit
3
/
" male
8
compression fitting.
WATER SOFTENER MODELS
Refer to your DishDrawer® User Guide
for how to set up your water softener.
WATER PRESSURE
Maximum
Water Softener Models
145 p.s.i. (1000kPa)
Other Models
145 p.s.i. (1000kPa)
DRAIN CONNECTION
3
Drain Hose Joiner to suit Ø
/
" ±
4
ELECTRICAL CONNECTION
110-120 VAC power outlet, 4.5 Amps Minimum.
WEIGHT
Full 107 lb (48kg) Prefinished
Empty 76 lb (34kg) Prefinished
THE CAVITY
+
These marks indicate mounting
screw tab locations
(refer to step 1 page 7)
Minimum
14.5 p.s.i. (100kPa)
4.3 p.s.i. (30kPa)
5
5
5
/
" and Ø
/
" ±
/
" waste tees.
64
8
64
+
NOTE: All depth measurements are taken
from the front face of the adjacent cabinetry.
NOTE: To align drawer front to adjacent
cabinetry, the product to countertop
clearance can be increased from
*
* Depth of product excludes
3
Curvature
/
" (10mm) and Handle.
8
LENGTH OF SERVICES
9
Drain hose - 88
/
" (2250mm)
16
7
Inlet hose - 68
/
" (1750mm)
8
Power supply cord - 44" (1125mm)
NOTE: Services approximately exit product 7
5
21
/
" (550mm) from front; 15
8
+
+
1
/
" (3mm).
8
(FROM PRODUCT EXIT POINT)
7
/
" (189mm) from left;
16
1
/
" (393mm) from top.
2
Important!
Adjacent cabinetry must
not extend above
cavity base.
WARNING!
Be sure the edges of the services hole
are smooth or covered. If the services
hole is through a metal partition the
hole must be protected with the Edge
Protector provided to prevent damage to
the power cord or hoses.
R
R
5