Galletti DST 66 기술 및 설치 매뉴얼 - 페이지 6

{카테고리_이름} Galletti DST 66에 대한 기술 및 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Galletti DST 66 8 페이지. Air destratifiers
Galletti DST 66에 대해서도 마찬가지입니다: 기술 및 설치 매뉴얼 (8 페이지)

페이지 인쇄

DST

INSTALLATION

When choosing an installation site, you should observe the following rules:

- do not install the unit in places where inflammable gases are present;

- do not expose the unit directly to sprays of water;

- install the unit on walls or ceilings able to withstand its weight; use

accessories suited to the purpose and suitable screw anchors.

Store the unit in its packing container until you are ready to install it to prevent

dust from infiltrating inside it.

Installation, maintenance and cleaning jobs may be carried out only with

the power supply disconnected.

Do not modify the indoor electrical connections and the components of the

unit.

Set the working temperature on the thermostat before lifting the unit.

Using suitable lifting equipment (a forklift truck is recommended), convey the

unit to the installation site and rest it on the floor with the fins facing down.

Use the suspending brackets on the back of the cabinet to support the

destratifier; before securing the unit to the ceiling ensure that the supporting

chains, the studs and the surface used are able to support it.

Maintain adequate space around the destratifier to allow it to operate

correctly and to allow routine and reactive maintenance to be performed.

When the installation has been finished, check the chains fastening to the

ceiling, check that the electrical wiring have been thightened, open the

deflecting baffles and connect the unit to power supply in order to check its

operation.

Make the electrical connections with the power supply disconnected, in

accordance with current safety regulations. All the wiring must be done by

qualified personnel.

Scrupulously follow the wiring diagram provided.

Check that the mains electricity supply is compatible with the voltage shown

on the unit rating plate.

Each unit requires a switch (IL) on the feeder line with a distance of at

least 3 mm between the opening contacts, and a suitable safety fuse

(FL).

400/3/50

Line circuit-breaker (NOT SUPPLIED)

Protection fuse (NOT SUPPLIED)

ISM

Overload cut-out

remote control switch

Thermostat

Motor

AP66000443 - 02

WIRING DIAGRAM

All copying, even partial, of this manual is strictly forbidden

1 3 5

ISM

2 4