HighPoint SSD7140A 매뉴얼 사용 - 페이지 9
{카테고리_이름} HighPoint SSD7140A에 대한 매뉴얼 사용을 온라인으로 검색하거나 PDF를 다운로드하세요. HighPoint SSD7140A 19 페이지. Using nvme raid aics with the dell precision 3930 rack workstation
HighPoint SSD7140A에 대해서도 마찬가지입니다: 빠른 설치 매뉴얼 (9 페이지), 빠른 설치 매뉴얼 (11 페이지), 빠른 설치 매뉴얼 (6 페이지)
페이지 인쇄
Using HighPoint NVMe RAID AICs with the Dell Precision 3930 Rack Workstation
3. Installing HighPoint NVMe RAID AIC into Dell Precision 3930
Rack Workstation
3.1 Install hardware
3.1.1 Recommended tools
a. Screwdriver (system cover require a screwdriver to open)
b. Wired ESD wrist strap (to prevent electrostatic accidents)
3.1.2 Installing hardware
a. Use a wired ESD wrist strap that is properly grounded.
b. Shut down the system.
c. Insert a screwdriver and turn counterclockwise to unlock the system cover
latch.
d. Lift the latch upward to remove the system cover.
e. Remove the riser1 module from the system.
f. Pull the riser1 module latch and remove the riser1 module filler bracket.
g. Holding the edge of the HighPoint NVMe RAID AIC, align the HighPoint NVMe
RAID AIC connector with the riser1 module slot and insert it downward.
h. If you are using the SSD7140A, SSD7540, RocketAIC 7140AW, or RocketAIC
7540HW, you will need to connect the power cable to the 8-pin power
connector on the system and to the 6-pin power connector on the side of the
HighPoint NVMe RAID AIC.
Notes:
If you are not using the SSD7140A, SSD7540, RocketAIC 7140AW, or
RocketAIC 7540HW, you can safely move to the next step.
You may need to purchase additional power cables.
9