HighPoint RocketRAID RR3740A 설치 매뉴얼 - 페이지 9

{카테고리_이름} HighPoint RocketRAID RR3740A에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. HighPoint RocketRAID RR3740A 11 페이지. Sata controller

RocketRAID 37xx/8xx/28xx Uniontech OS Server 20 Installation Guide

Step 1 Obtain and install the Driver Module

Extract the driver archive to a temporary directory and execute the install.sh to install the

driver to the system. For example:

# mkdir /tmp/dd

# tar xzvf RR3740A_UOS20_Server_1050d_aarch64_vx.x.x_xx_xx_xx.tar.gz

-C /tmp/dd

# cd /tmp/dd

# sh install.sh

If the driver of previous version has been in the initrd image, the installer will update the

initrd image or it will make the driver automatically loaded while system up.

Now you can inform the system to automatically mount the array by modifying the file

/etc/fstab. E.g. you can add the following line to tell the system to mount /dev/sda1 to

location /mnt/raid after startup:

Once the driver is running, you can monitor it through the Linux proc file system support.

There is a special file under /proc/scsi/rr3740a/. Through this file you can view driver

status and send control commands to the driver.

Note

The file name is the SCSI host number allocated by OS. If you have no other SCSI cards

installed, it will be 0. In the following sections, we will use x to represent this number.

Using the following command to show driver status:

# cat /proc/scsi/rr3740a/x

This command will show the driver version number, physical device list and logical device

list.

HighPoint RAID Management Software is used to configure and keep track of your hard

disks and RAID arrays attached to RR3740A controller. Installation of the management

software is optional but recommended.

Please refer to HighPoint RAID Management Software documents for more information.

When the system updates the kernel packages, the driver module rr3740a.ko should be

built and installed manually before reboot.

/dev/sda1

/mnt/raid

ext3

defaults

0 0

- 7 -