HighPoint RR620L 설치 매뉴얼 - 페이지 5

{카테고리_이름} HighPoint RR620L에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. HighPoint RR620L 16 페이지. Controller linux debian

Linux Debian on RR640L/620L Installation Guide

1 Overview

The purpose of this document is to provide clear instructions on how to install Linux

Debian on the RR Series RAID controller.

Supported system: Debian10.1/10.2/10.3/10.4/10.5/10.6/10.7/10.8/10.9/11.3/



11.4/11.5/11.6

Supported controller: RR640L/620L



2 Installing Linux Debian on RR Series RAID

controller

If you would like to install Linux Debian onto drives attached to RR Series RAID

controller, please perform the following operations:

After you attach your hard disks to RAID controller, you can use EFI Utility to configure

your hard disks as RAID arrays, or just use them as single disks.

Before installation, you must remove all the Hard disks, which are not physically attached

to RAID controller, from your system.

Note

RAID Controller support EFI boot. If you have other SCSI adapters installed, you must

make sure the RR Series controller EFI will be loaded firstly. If not, try to move it to

another PCI slot. Otherwise you may be unable to boot up your system.

In your system EFI SETUP menu, change Boot Sequence in such a way that the system

will first boot from EFI CDROM or EFI a Bootable USB drive, after you finish

installation, set RR Series RAID as the first boot device to boot up the system. Refer to

your motherboard EFI manual to see how to set boot sequence.

Set UEFI setting with SuperMicro X11DPi-NT motherboard as an example.

"Advanced->PCIe/PCI/PnP Configuration->CPUSlot PCI-E OPROM"

to "EFI". Suppose Controller is connected to motherboard CPU1 Slot 2 PCI-E

X16, then you should set "CPU1 Slot 2 PCI-E X16 OPROM" to "EFI";

- 1 -