Agrosta 100USB 빠른 시작 매뉴얼 - 페이지 3

{카테고리_이름} Agrosta 100USB에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Agrosta 100USB 8 페이지.

AGROSTA®100 USB

DIGITAL FIRMNESS INSTRUMENT

STARTING / INSTALLING SOFTWARE

1) Install the soft completely (driver installation as well – check that driver installation is not blocked by

your system)

2) Close the soft if it has started after setup

3) Connect your device

4) Wait one minute till your computer recognizes it, and till the internal software inside the device starts

(If you don't wait, you will obtain bad values)

5) Launch the soft from your desktop

6) The soft starts immediately, you can choose the COM port corresponding to your device on top – left

side – Click on the COM port corresponding to your device – If you have a doubt, start the device

manager of your PC, and find the COM port corresponding to "Ftdi" – Or, more easy, try each COM

port, wait one second, and press the tip on a table in order to see whether you obtain a measure

7) Place your sensor in the work position, tip free, and press on the button "RECORD SENSOR

FREE IN WORK POSITION"

8) Once the device receives the origin position, « OK » appears during one second :