HighPoint SSD7103 설치 매뉴얼 - 페이지 3

{카테고리_이름} HighPoint SSD7103에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. HighPoint SSD7103 11 페이지. Linux ubuntu desktop 19.10
HighPoint SSD7103에 대해서도 마찬가지입니다: 설치 매뉴얼 (11 페이지), 설치 매뉴얼 (11 페이지), 설치 매뉴얼 (15 페이지), 설치 매뉴얼 (12 페이지), 설치 매뉴얼 (12 페이지), 설치 매뉴얼 (12 페이지), 설치 매뉴얼 (13 페이지), 설치 매뉴얼 (11 페이지), 빠른 설치 매뉴얼 (9 페이지), 설치 매뉴얼 (12 페이지)

HighPoint SSD7103 설치 매뉴얼
SSD7103 Linux CentOS7.7 Installation Guide

1 Overview

The purpose of this document is to provide clear instructions on how to install Linux
CentOS7.7 on the SSD7103 controller.
For CentOS7.7 (kernel: 3.10.0-1062.el7.x86_64)
Mirror link:
http://mirrors.cqu.edu.cn/CentOS/7.7.1908/isos/x86_64/CentOS-7-x86_64-DVD-1908.iso
MD5: 7b209a576190cfe414e6b2d0633c4a81

2 Installing Linux CentOS7.7 on SSD7103 controller

If you would like to install Linux CentOS7.7 onto drives attached to SSD7103 controller,
please perform the following operations:

Step 1 Prepare Your Hardware for Installation

After you attach your NVMe SSD to SSD7103 controller, you can use SSD7103 EFI
Utility to configure your NVMe SSD as RAID arrays, or just use them as single disks.
Before installation, you must remove all the NVMe SSD, which are not physically
attached to SSD7103 controller, from your system.
Note
SSD7103 only support EFI boot. If you have other SCSI adapters installed, you must
make sure the SSD7103 controller EFI will be loaded firstly. If not, try to move it to
another PCI slot. Otherwise you may be unable to boot up your system.

Step 2 Check System EFI Settings

In your system EFI SETUP menu, change Boot Sequence in such a way that the system
will first boot from EFI CDROM, and then from SSD7103 RAID. Refer to your
motherboard EFI manual to see how to set boot sequence.
If your EFI settings do not support such a boot sequence, you can first set it to boot from
EFI CDROM. After you finish installation, set SSD7103 RAID as the first boot device to
boot up the system.
1. Set UEFI setting with ASUS PRIME X299 -DELUXE motherboard as an example:
a.
Set "Boot from Storage Devices" to "UEFI driver first";
- 1 -