Emerson Fisher 114PL 사용 설명서

{카테고리_이름} Emerson Fisher 114PL에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Emerson Fisher 114PL 4 페이지. High-pressure reducing and low-flow system

페이지 인쇄
Emerson Fisher 114PL 사용 설명서
Instruction Manual
D104438X012
May 2022
Type 114PL High-Pressure Reducing and
Low-Flow System
Table of Contents
Introduction .................................................................. 1
Specifications .............................................................. 2
Principle of Operation .................................................. 2
Installation ................................................................... 2
Startup ......................................................................... 4
Maintenance ................................................................ 4
Parts Ordering ............................................................. 4
▲
WARNING
Failure to follow these instructions or
to properly install and maintain this
equipment could result in an explosion
and/or fire causing property damage and
personal injury or death.
Fisher™ regulators must be installed,
operated and maintained in accordance
with federal, state and local codes, rules
and regulations and Emerson Process
Management Regulator Technologies,
Inc. instructions.
If the regulator vents gas or a leak
develops in the system, service to
the unit may be required. Failure
to correct trouble could result in a
hazardous condition.
Call a gas service person to service the
unit. Only a qualified person must install
or service the regulator.
Figure 1. Type 114PL
Introduction
Scope of the Manual
This manual provides instructions for installation,
startup, adjustment and maintenance for Type 114PL
Pressure Reducing System. For pilots maintenance,
instructions and parts list, see Type BSL85 Instruction
Manual, D103711X012.
Product Description
Type 114PL
Type 114PL High-pressure Reducing and Low-flow
System is a battery of three Type BSL85 Pilots (see
Instruction Manual, D103711X012) where two of
them are pneumatically loaded and the third one
is spring-loaded. It is designed for high-pressure
reduction with low-flow conditions.
Type RPE (Electric Heater)
Type RPE can be used together with the Type 114PL.
Type RPE is used for reheating gas supplying
pressure reducing regulator pilots. Type RPE avoids
the inconveniences caused by freezing which
occur during large pressure drops. (See Instruction
Manual, D103694X012).
Type 114PL