adeptus 6+2 Drawer Wide Roll Cart 76182 조립 지침 매뉴얼 - 페이지 7

{카테고리_이름} adeptus 6+2 Drawer Wide Roll Cart 76182에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. adeptus 6+2 Drawer Wide Roll Cart 76182 8 페이지. Matte black/white finish

페이지 인쇄

adeptus 6+2 Drawer Wide Roll Cart 76182 조립 지침 매뉴얼

ASSEMBLE THE LARGE DRAWERS

• LINE UP THE BOTTOM EDGE OF THE LARGE DRAWER

SIDE (PART 13) WITH THE BOTTOM EDGE OF THE

LARGE DRAWER FRONT (PART 12).

• JOIN THE PARTS USING TWO SCREWS (PART B) AS

SHOWN IN THE DIAGRAM.

NOTE: THE SCREWS' SHARP TIPS ARE SELF TAPPING, SO THE

DRAWER FRONT DOES NOT NEED A PILOT HOLE. THE SHARP TIP

STARTS THE HOLE, AND THE SCREW THREADS WILL SECURE THE

PART IN PLACE FOR A TIGHT FIT.

• REPEAT ON THE OTHER SIDE OF THE DRAWER.

• SLIDE IN DRAWER BOTTOM (PART 10) TROUGH

GROOVES IN THE BIG DRAWER SIDES (PART 13).

THIS WILL START SQUARING UP THE DRAWER.

• LINE UP DRAWER BACK (PART 14) WITH BOTH DRAWER SIDES

(PART 13). CHECK THAT IT IS SQUARE.

• SCREW THE LARGE DRAWER BACK (PART 14) TO THE

LARGE DRAWER SIDES (PART13)

• TURN THE DRAWER OVER.

CONFIRM THE DRAWER BOTTOM (PART 10) COVERS THE DRAWER BACK

(PART 14). NAIL THE DRAWER BOTTOM (PART 10) THROUGH TO THE

LARGE DRAWER BACK (PART 14) USING (2) NAILS (PART F).

F=04

B=16

Screw

Nail

3,0 x 25mm

INSERT DRAWERS AND COMPLETE ASSEMBLY

• THE DRAWER SIDES HAVE A CHANNEL THROUGH THE

MIDDLE OF THE PART. THIS CHANNEL SLIDES OVER

THE DRAWER RUNNERS (PART D).

• SLIDE ALL DRAWERS IN.

CHECK THE DRAWERS RUN SMOOTH.

ONE DRAWER FRONT SHOULD NOT OVERLAP

ANOTHER DRAWER FRONT EDGE.

IF THERE IS A PROBLEM, IT IS LIKELY THE DRAWER FRONT IS NOT

ASSEMBLED LEVEL. SIMPLY BACK OUT ONE SET OF THE SCREWS

ON A DRAWER SIDE AND ADJUST UNTIL IT IS TO YOUR

SATISFACTION.

REMEMBER TO LINE UP THE BOTTOM EDGES OF THE DRAWER

SIDE AND DRAWER FRONT.

•

STEP BACK TO LOOK AT UNIT. YOU MAY PREFER TO

MOVE ONE DRAWER TO ANOTHER´S POSITION.

TIP: To make this step easier, place the drawer upside

down on a counter with the drawer front hanging off

the edge. This will allow the drawer box to lay flat and

provide better control for hammering the nails.

7/8

CONTAINED