DD Audio DM1000a 소유자 매뉴얼 - 페이지 13

{카테고리_이름} DD Audio DM1000a에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DD Audio DM1000a 19 페이지. Class d monoblock amplifier

INSTALLATION

1. Disconnect the negative cable from the car battery.

2. Due to the power requirements of the Amplifier, the +12V

connection should be made directly to the positive (+)

terminal of battery. For safety measures, install an in-line

fuse holder (not included) as close to the battery's positive (+)

terminal as possible. The fuse ampere rating should not exceed the total

value of the amplifier's rated maximum current draw. If the fuse is further

than 18 inches (wire length) from the battery you should re-evaluate the

wire and fuse placement.

Run the power wire from the battery to the amplifier. To avoid a potential

short to the body and a possible fire, this cable should never be ran outside

of the vehicle. You will also need to make sure no trim screws or sharp body

metal will penetrate the power cable shielding. Don't install the fuse yet.

This will be the last thing you do.

3. Connect the ground wire directly to the chassis of your vehicle. The

grounding location should be made on metal as close to the amplifier as

possible. Remove all paint, sound deadener, etc. from the area of grounding

connection. Do not use seat belt bolts for grounding. It is advisable to test the

ground with an ohmmeter. Test between the grounding point and the negative

battery cable to insure a good low resistance connection (<0.5 Ohm).

4. Run the REM Turn-On wire from the an ignition controlled +12V source.

This will turn "ON" the amplifier remotely when the vehicle's stereo is turned

"ON". NOTE IF YOUR RADIO DOES NOT HAVE A +12 VOLT OUTPUT

LEAD WHEN THE RADIO IS TURNED ON, THE AMPLIFIER CAN BE

CONNECTED TO AN ACCESSORY CIRCUIT IN THE VEHICLE THAT IS

LIVE WHEN THE KEY IS "ON".

5. Run the RCA cables if they will be used for the application or make your

high-level signal connections.

6. Run the speaker wire to the speakers. It is advised that you leave some

extra wire at this point. You can "clean it up" later.

7. Connect the power and ground to the amplifier. Make sure the polarity

(+ and -) is correct to avoid damaging the amplifier. Only after this step

should you install the fuse at the battery.

8. Connect the remote wire from the head unit to the amplifier. At this time you

should turn on the amp and make sure it turns on properly and does not go

into protect.

DD AUDIO / CLASS D MONOBLOCK AMPLIFIER /