HighPoint RocketRAID 640L 빠른 설치 매뉴얼 - 페이지 5

{카테고리_이름} HighPoint RocketRAID 640L에 대한 빠른 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. HighPoint RocketRAID 640L 8 페이지. 6gb/s sata pci-express 2.0 raid hba

BEEP1

PORT1 to

PORT4

Active/FAIL LED PIN connector:

This connector is one-pin connection from HBA to LED on chassis.

For detail LED connection requirement and display information,

please refer to:

http://www.highpoint-tech.com/PDF/LED_connection.pdf

Hardware Installation

Installing the RocketRAID 600L Series HBA

Note: Make sure the system is powered-off before installing the

RocketRAID 600L Series HBA.

1. Open the system chassis and locate an unused PCI-E (2.0/1.0) (x4,

x8, x16) slot or (3.0) (x16) slot.

2. Remove the PCI slot cover.

3. Gently insert the RocketRAID 600L HBA into the PCI-E slot, and

secure the bracket to the system chassis.

4. After installing the adapter, attach the hard disks or disk enclosure

to the RocketRAID 600L HBA using the SATA cables.

5. Close and secure the system chassis.

RocketRAID 600L HBA BIOS

After installing the RocketRAID 600L Series HBA, and powering on the

system, the adapter BIOS should post.

The BIOS will scan for devices and display information about each disk.

I2C Connector

SATA

SATA and eSATA

Connector

Alarm Buzzer

Connector

N/A

eSATA

Connector

Mini-SAS