adeptus 76152 조립 지침 매뉴얼 - 페이지 6

{카테고리_이름} adeptus 76152에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. adeptus 76152 7 페이지. 6 drawer roll cart

페이지 인쇄

ATTACH THE BACK PANEL

Use all back

panels nails.

Evenly spaced,

they help make

the unit strong.

• HOLD THE (PART 4) BACK PANEL IN THE

GROOVES INSIDE THE UNIT´S SIDES.

• ALSO MAKE SURE THE BACK PANEL FITS IN THE

GROOVE AT THE BACK OF THE TOP.

• CHECK THAT THE UNIT IS SQUARE.

• SECURE THE (PART 4) BACK PANEL USING THE (PART F)

NAILS.

F=16

Nail

ASSEMBLE THE DRAWERS

• LINE UP THE BOTTOM EDGE OF THE DRAWER

SIDE (PART 8) WITH THE BOTTOM EDGE OF THE

DRAWER FRONT (PART 11).

• JOIN THE PARTS USING TWO SCREWS (PART B)

AS SHOWN IN THE DIAGRAM.

NOTE: THE SCREWS' SHARP TIPS ARE SELF TAPPING, SO THE

DRAWER FRONT DOES NOT NEED A PILOT HOLE. THE SHARP

TIP STARTS THE HOLE, AND THE SCREW THREADS WILL

SECURE THE PART IN PLACE FOR A TIGHT FIT.

• REPEAT ON THE OTHER SIDE OF THE DRAWER.

• SLIDE IN DRAWER BOTTOM (PART 10) TROUGH GROOVES

IN THE DRAWER SIDES (PART 8). THIS WILL START

SQUARING UP THE DRAWER.

• LINE UP DRAWER BACK (PART 9) WITH BOTH DRAWER

SIDES (PART 8). CHECK THAT IT IS SQUARE.

• SCREW THE DRAWER BACK (PART 9) TO THE DRAWER

SIDES (PART 8).

• TURN THE DRAWER OVER. CONFIRM THE DRAWER BOTTOM

(PART 10) COVERS THE DRAWER BACK (PART 9). NAIL THE

DRAWER BOTTOM (PART 10) THROUGH TO THE DRAWER

BACK (PART 9) USING (2) NAILS (PART F).

B=48

F=12

Screw

Nail

3,0 x 25mm

NOTICE:

TIP: To make this step easier, place the drawer upside

down on a counter with the drawer front hanging off

the edge. This will allow the drawer box to lay flat and

provide better control for hammering the nails.

CONTAINED

8 9

6-07