DDC Sentry VOIP V2 매뉴얼 - 페이지 7

{카테고리_이름} DDC Sentry VOIP V2에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DDC Sentry VOIP V2 20 페이지.

SETTING MENU

On entering the Settings Menu, the current parameters of the telephone will be displayed.

Submenu's are shown on the left of the WEB page, the first section is for 'Network settings' and

will enable you to change IP address, subnet mask and gateway and option to set DNS server

setting. The other sections are describe in the following pages of this manual.

Network Settings

The Connection Type enables the unit to be connected via a STATIC IP, DHCP or PPPoE

address.

If the connection is DHCP then the IP address, Mask and Gateway are automatically

assigned by the server.

When set to a Static IP, a suitable IP address, Subnet Mask and Gateway address will be

required to suit the local area network.

Alternatively, if connection is via a Internet Service Provider (ISP) then select PPPoE and set

the user ID and PIN as supplied to you from your ISP.

Note that for some servers, the connection type may need to be set to DHCP.

If you change the IP address you are then required to restart by logging in using the new IP

address. Do not click on 'go back one page' of the browser (usually in the top left corner).

In most cases the DNS Server IP can remain set to Auto DNS, in this mode the DHCP sever

will assign the DNS automatically. If however, it is required, enable Manual DNS and set the

Primary and Secondary DNS address.

If the network switch provides QoS traffic control, then set the Layer 2 & 3 QoS values to

match.

Dallas Delta Corporation Pty.Ltd.

Page 7