DDK CM10-SP2S-S(D6) 조립 설명서 - 페이지 4

{카테고리_이름} DDK CM10-SP2S-S(D6)에 대한 조립 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DDK CM10-SP2S-S(D6) 12 페이지. Plug connector cable

3. Cable Assembly Process

Cut the cable to the following dimensions:

Note! Not to change cable length.

* Cable cut length = 35± ± ± ± 0.5mm for CM10-SPxxS(D6) + Cable length

Insert the clamp nut, the cable clamp, the bushing and the back shell to the cable.

Note! Pay attention to the direction each part is inserted.

Make sure that every part is inserted.

Back shell

Strip the cable's sheath to the A length, cut the wire set at its root and strip the core wire to the B length.

Note! Make sure to strip the cable to the correct length.

Do not leave cutting or scratch to the cable core.

* When making CM10-SP10S(D6), strip the cable for No. 10 terminal in a way that the A length

becomes 1mm longer than that of other cables.

(This is to prevent excessive tension of the cable when inserting the contact to the housing

in the next process.)

(A+1mm for No. 10 terminal only)

Ｂmm

Core wire

= 35± ± ± ± 0.5mm + Cable length

Bushing

Ａmm

Cable core

Cable length

Cable clamp

Product name

Sheath

CM10-SP10S-×(D6)

CM10-SP2S-×(D6)

Material No.

Page

TC-605

3/11

Cable

Clamp nut

18.5 to 19.5

4.5 to 5.0

17.5 to 18.5