Galley-Mate 6001 설치 및 운영 매뉴얼 - 페이지 7

{카테고리_이름} Galley-Mate 6001에 대한 설치 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Galley-Mate 6001 10 페이지. Reverse osmosis high purity water production system

페이지 인쇄

WATER FEED SOURCE AND REJECT DRAIN CONNECTIONS

FEED WATER CONNECTIONS:

The feed water connection to the Galley-Mate marine

water purification system will vary from vessel to

vessel, depending on vessel size and type of piping

used on board.

We include a 1/4" Self-Piercing valve that is normally

used under the galley sink on vessels that have the

cold water faucet piped with rigid copper risers.

(See figure 1-A.)

Today, many vessels use quick connect plastics for

fittings and connectors along with the plastic tubing

that is available with specialty fittings such as those

supplied by Neptune Plumbing Systems, on a wide

range of production boats. For connection to plastic

tubes, we recommend locating a "T" with ball valve

(not supplied) to make the 1/4" connection to the Gal-

ley-Mate Feed Water port.

(See Figure 1-B)

Other connection fittings

are available. Feed connec-

tion can be achieved with

shut off of a variety of

styles. Although pre-filter

has a built in shut–off a

feed water shut off is re-

quired for a proper install.

FIGURE 1-A

1/4" Self Piercing Saddle Valve

Figure 1-B

Feed Water Source

Plastic "T" Fitting

1/4" RO Feed

Brass/Plastic Valve

DRAIN CONNECTIONS:

All Membrane Purification Systems have one feed water

inlet and two outlets, a purified water stream and the

reject drain stream. The reject flow must be taken to a

drain, which will vary from vessel to vessel.

We include a standard drain saddle valve which fits any

1 1/2" OD straight wall pipe. This fitting may be used in

under galley sink installations where the riser above the

"P" Trap is 1 1/2" in diameter. This fitting can be in-

stalled either in a vertical position or on a horizontal

position as long as the fitting is above the trap. When

installing the Galley-Mate assembly in an engine room

you may utilize the saddle fitting on any non– pressur-

ized straight wall pipe such as PVC. Do not install into

any pipe sections that are pressurized or in the position

of holding water in a void. ( See Figure 1-C ).

Select location for the drain clamp. Position the threaded

Figure 1-C

1/2 of the saddle on pipe and mark the pipe through the

threaded opening. Drill a 1/4" hole at marked location

into pipe.

On board drain connections will vary depending on the

location for the installation of the system. Different

adaptors may be utilized when draining to an existing

thru-hull drain line. On some vessels, with larger fresh

water tanks and frequent water-maker fills from sea wa-

ter, the RO drain may be diverted back to the fresh water

storage tank for a "O" waste system. If the TDS is low

in the tank, the rise of TDS from the RO will be insig-

nificant to the tank volume. We recommend our Water-

Mate systems if this drain connection is used. Ask your

Distributor for Water-Mate product data.