Gallien-Krueger 1001RB 소유자 매뉴얼 - 페이지 10

{카테고리_이름} Gallien-Krueger 1001RB에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gallien-Krueger 1001RB 17 페이지. 1001rb series

An electronically balanced output, that you can run

to your P.A. system.

Selects the direct out signal from before or after the EQ.

Controls the level at the direct out jack.

A standard ¼" input jack and input attenuator button.

The button is generally left out, except in rare cases when

the clip LED flashes.

Set this switch to "On" when tuning up. No signal will be

sent to the speakers, or the P.A. system.

Sets pre-amp gain after the input stage. It is used in

conjunction with the input pad, to optimize the amplifier's

headroom.

Setting this button voices the pre-amp for basses with "B"

tuning. Leave it out and the amp is voiced like the 800RB,

for 4 string basses.

Drops the mid-range frequencies while boosting lows &

highs.

Adds edge and definition to higher frequencies.

Boost and cut at 7 kHz +15dB shelving type. Add or

remove edge and definition.

13 14 15 16

10 11

Boost and cut at 1 kHz +10dB, "Q Optimized," band

pass type. Works on lower string harmonics, and

effects the punch of your sound.

Boost and cut at 250Hz +10dB, "Q Optimized,"

band pass type. Works on the main body of your sound.

Boost and cut at 60Hz +10dB, shelving type. Controls

low end push.

A post EQ gain stage using GIVE technology which adds

"growl" as it is turned up.

Controls output level to tweeter.

Cuts frequencies above 10kHz, producing a more

"cone" like sound from the tweeter.

Controls output level of 540W amplifier. For Bi-Amp

operation, this controls the woofer level.

Set this button to engage the electronic crossover for the

woofer. The tweeter is always crossed over.

Send and return jacks provided for the insertion of

effects after the EQ, but before the boost section. Some

effect units have gain, turning the BOOST down, will

compensate for this.

Output to tuner.

Turns the amplifier on or off. Should a problem occur

during operation press this switch first.