Gallien-Krueger 1001RB/210 소유자 매뉴얼 - 페이지 12

{카테고리_이름} Gallien-Krueger 1001RB/210에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gallien-Krueger 1001RB/210 16 페이지. Artist series
Gallien-Krueger 1001RB/210에 대해서도 마찬가지입니다: 소유자 매뉴얼 (17 페이지)

페이지 인쇄

Rear Panel Controls

1- AC Receptacle:

The power cord is detachable and plugs in here.

2- 700W/480W Amp Only:

700W/480W power amp output for Full-Range

operation only. They deliver 700W/480W into 4

Ohms. Lower impedances should not be used.

Higher impedances such as 8 Ohms, 16 Ohms, or No

Load are acceptable. One 8 Ohm cabinet is okay. One

4 Ohm and one 8 Ohm is not recommended. No

damage will result from operating the amplifier with

the speakers disconnected.

3- "Speakon" Outputs:

Enables BI-AMP operation by connecting a GK-RBH

Series cabinet with the provided 4 conductor Speakon

cable. This connects the Tweeter/50W amplifier

allowing the Tweeter control on the front panel to

control the signal going to the horn. See Bi-Amp and

Normal Operation on page 7 for more information.

Caution:

Do not connect a Speakon cable labeled "Bridge

Mode" to the 1001RB-II/700RB-II. This may result in

damage to the amplifier.

Maximum Recommended Load:

One 4 Ohm or two 8 Ohm cabinets on the Woofer/

Main Amp.

One or two 8 Ohm horns on the 50W Amp.

700RB-II/1001RB-II Series

CAUTION:

UNDER NO CIRCUMSTANCES

SHOULD THE WOOFER/MAIN

AMP AND THE 50W/TWEETER

AMP BE CONNECTED TO-

GETHER OR BE CONNECTED

TO THE SAME SPEAKER !!!