Gallien-Krueger 2001RB 소유자 매뉴얼 - 페이지 8

{카테고리_이름} Gallien-Krueger 2001RB에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gallien-Krueger 2001RB 15 페이지. Bass amp and preamp
Gallien-Krueger 2001RB에 대해서도 마찬가지입니다: 소유자 매뉴얼 (20 페이지), 소유자 매뉴얼 (20 페이지)

페이지 인쇄

Bridged Mode Operation

Note: To operate the 2001RB in bridge mode, you must

use the L/BR Speakon outputs only. Using the Left

channel, ¼" outputs will not work, since the ground for

those jacks are internally disconnected when in bridge

mode. Using any of the Right channel ¼" or Speakon

outputs is not recommended as this will result in a

malfunction, or undesired operation of the ampliﬁer.

Make sure nothing is connected to any of the Right

channel outputs.

Slide the Bridge Mode switch on the back of the amp

from dual mono, to Bridge.

The Right Level knob on the back of the amp should be

turned all the way up (clockwise) or power output will

be compromised.

2001RB setup for Bridged Bi-Amp Operation:

2001RB setup for Bridged Normal Operation:

2001RB

-1

Since Bridge Mode operation is only available through

the Speakon outputs, the type of Speakon cable you

need depends on the brand of cabinets that you are

using. When using our RBH or NEO Series cabinets,

using our four conductor Speakon to Speakon biamp

cable will allow Bridged Mode and biamp operation

simultaneously. Since the 50W horn amps are always

active, this allows you to deliver 1080W to your cabinet

and 50W to the horn. When using other brand name

cabinets a two conductor Speakon cable will be needed

but the biamp feature will not work. It is very

important, that these two conductor Speakon cables are

wired correctly. The 1+ pin connects to the tip of the

¼" plug and the 1- pin connects to the shield.

DO NOT USE 'BRIDGED MODE' SPEAKON

CABLES WITH THIS AMP!

These are wired 1+ and 2+ which would connect the

horn and woofer amps together. This could cause

damage to your cabinet and/or the ampliﬁer.