Frigidaire 200 Series 사용 및 관리 매뉴얼 - 페이지 11
{카테고리_이름} Frigidaire 200 Series에 대한 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Frigidaire 200 Series 18 페이지. Frigidaire dishwasher
Frigidaire 200 Series에 대해서도 마찬가지입니다: 사용 및 관리 매뉴얼 (16 페이지), 사용 및 관리 매뉴얼 (18 페이지), 사용 및 관리 매뉴얼 (16 페이지), 사용 및 관리 매뉴얼 (16 페이지)
페이지 인쇄
Dishwasher Dispenser
& Detergents
Rinse Aid
Rinse aid greatly improves drying and
reduces water spots and filming. Water
sheets off dishes rather than forming water
droplets that cling and leave spots.
A dispenser, located next to the detergent
cup, automatically releases a measured
amount of rinse aid during the last rinse. If
spotting and poor drying are problems,
increase the amount of rinse aid dispensed by
rotating the dial to a higher number. The dial
is located under the dispenser cap. The
indicator will be dark when full and will show
clear when it is time to refill.
To add liquid rinse aid, turn dispenser cap 1/4
turn counterclockwise and lift out. Pour in
rinse aid until liquid touches the indicated fill
level. Replace cap.
Do not overfill since this can cause oversudsing.
Wipe up any spills with a damp cloth.
The dispenser holds enough for 35 to 140
washes, depending on setting.
Dispenser Opening
Dispenser Cap
(continued)
Indicator
Adjustable setting
Factors Affecting
Performance
Water Pressure
The hot water line to dishwasher must provide
water pressure between 20 and 120 psi.
Low water pressure may occur when laundry or
showers are in operation. Wait until water use
is reduced before starting dishwasher.
Water Temperature
Hot water is needed for best dishwashing and
drying results. Water entering dishwasher
should be at least 120°F (49°C) to give
satisfactory results.
To check water temperature entering
dishwasher:
Turn on hot water faucet nearest dishwasher
for several minutes to clear cool water from
pipes.
Hold a candy or meat thermometer in stream
of water to check the temperature.
If temperature is below 120°F (49°C), have a
qualified person raise the hot water heater
thermostat setting.
Important: Before starting a cycle, run hot
water to clear cool water from pipe.
11