Dynex DX-32L150A11 펌웨어 업데이트

{카테고리_이름} Dynex DX-32L150A11에 대한 펌웨어 업데이트을 온라인으로 검색하거나 PDF를 다운로드하세요. Dynex DX-32L150A11 2 페이지. Quick setup guide (french)
Dynex DX-32L150A11에 대해서도 마찬가지입니다: 빠른 설정 매뉴얼 (2 페이지), 자주 묻는 질문 (8 페이지), (빠른 설치 가이드 (2 페이지), (빠른 설치 가이드 (2 페이지), (프랑스어) 빠른 설치 매뉴얼 (2 페이지), (프랑스어) 빠른 설치 매뉴얼 (2 페이지)

Tuner Firmware Update Process for Dynex Model DX‐32L150A11

1. IMPORTANT: Please completely read these instructions prior to starting your

update process.

2. Determine the proper Rev id by looking at the sticker on the side of the TV (see photo

below) and write down the Model and Rev id for use later in this process.

3. Insert USB drive to your PC or Mac

4. USB drive being used must not have any folders or additional files on the device.

5. Download the firmware that matches the Model and Rev id of your TV.

6. To download firmware click on the "Support/Downloads" tab; then locate the

corresponding Rev id of your TV.

7. Click on the firmware link titled "LC32KS70CMO.Bin"(Some maybe LC32KS70

AUO.Bin) when the pop up box appears select "Save" and choose the destination of

your USB drive.

a. Note: Do

b. Note: This file is <5 Megs in size; download time should be less than 1 minute.

8. Once down load is complete safely remove your USB drive.

9. Disconnect the AC power from your wall outlet for the TV

10. Insert USB device into the SERVICE PORT; located in one of 3 places, back, side or

bottom. The correct port will be labeled either Service or Service/USB. See photo below

NOT

change the name of the file.