Frigidaire 640 Series 사용 및 관리 매뉴얼 - 페이지 11
{카테고리_이름} Frigidaire 640 Series에 대한 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Frigidaire 640 Series 16 페이지. Frigidaire fdb641rjs1: operating instruction
Frigidaire 640 Series에 대해서도 마찬가지입니다: 사용 및 관리 매뉴얼 (16 페이지), 서비스 데이터 시트 (2 페이지), 사용 및 관리 매뉴얼 (14 페이지)
페이지 인쇄
Connecting and Disconnecting the Portable/
Convertible Dishwasher
The portable/convertible dishwasher must be connected to a faucet and electrical outlet each time it
is used. Follow directions on this page to properly connect dishwasher.
Faucet Adapter Assembly
For Outside
Threaded
Faucet
Use Thin
Washer Only
Adapter
(Dual Thread)
Connecting the Portable Faucet
Adapter Assembly
Collar
Coupler
For Inside
Threaded
Faucet
Use Thick
and
Thin
Washers
Two Brass Screens
should be below
the rubber washers
IMPORTANT: Make sure door is latched
before moving dishwasher.
The power cord, faucet coupler and hoses are
located in a compartment in back of
dishwasher. A special adapter must be
installed on faucet before you can connect
dishwasher.
1. Remove faucet adapter assembly from
literature package.
2. Unscrew existing sink faucet aerator.
3. Check faucet spout to see if threads are
inside or outside.
• If threads are on inside of faucet spout,
use both thick and thin rubber washers.
• If threads are on outside of faucet spout,
use thin rubber washer only.
• If faucet has no threads, an adapter kit
with instructions for attachment to a non-
threaded spout is available at most
hardware stores.
4. Assemble faucet spout as shown. Make
sure the two brass screens are located
below the rubber washers.
Connecting the Portable/Convertible
Dishwasher
1. Run water at faucet until it is hot. Turn off
faucet.
2. Pull hoses out of compartment.
3. Push collar down and slip faucet connector
onto faucet adapter.
4. When connector snaps into place, release
collar.
5. Slowly turn on hot water all the way.
6. Plug power cord into grounded outlet.
11