Gallien-Krueger MB FUSION 소유자 매뉴얼 - 페이지 7
{카테고리_이름} Gallien-Krueger MB FUSION에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gallien-Krueger MB FUSION 12 페이지.
페이지 인쇄
G N D
GND
LIFT
A C I N P U T
1 2 0 V / 6 0 H z
19
20
Top Panel Features (continued)
Deep: The Deep switch extends the low frequency
17
range of the amplifier to accommodate the extra
low range of the B string on a 5 or 6 string bass.
Users of 4 string basses may also find interesting
and desirable results with this filter as well.
Limiter: When this button is engaged it prevents
18
the power amp from distorting. It is recommended
that this feature is used for during high volume
applications.
Rear Panel Features
AC Receptacle: The detachable power cord plugs
19
in here.
Ground Lift: This switch disconnects the ground
20
of the balanced, XLR output to eliminate hum and
buzz when connecting to equipment that is
running on a different ground system.
Balanced
Direct
Out: This
21
balanced output allows a direct connection to a
P.A. system.
Pre/Post EQ Button: This button switches the
22
direct out signal to be before or after the EQ.
Foot switch Input: A foot switch is provided to
23
engage Boost and Master B modes.
Tuner Output: This output comes directly off of
24
the input stage and can be patched to a tuner using
a shielded patch cord. This output is unaffected by
the Tuning Mute Feature.
Return: This input allows the signal from
25
outboard effects devices to be inserted before the
boost section.
Send: This output allows signal from the preamp
26
to be fed to outboard effects devices from a point
after the EQ section.
MB FUSION
D I R E C T O U T
F T . S W I T C H
T U N E R
E Q
PRE
POST
22
21
23
24
27
28
29
electronically
P A T C H B A Y
H E A D P H O N E S ( 1 )
R E T U R N
S E N D
F X
L I N E O U T ( 2 )
26
25
27
Headphone/Line out: When switched, this output
allows the user to send a direct (unbalanced) line
out to devices with unbalanced inputs such as
personal multitrack recorders. This connection
requires a shielded patch cord. Unswitched, this
headphone jack can be used to monitor your
playing with headphones.
Headphone/Line out switch: This switch toggles
the output from headphone to line out.
Speaker: Power amp output to speaker cabinet.
Delivers 500w into 4 Ohm loads. Lower
impedances such as 8 Ohms or 16 Ohms and no
load are acceptable. One 4 Ohm speaker and one 8
Ohm speaker is not recommended. This unique
speaker output allows you to use a ¼" plug or the
high current, twist-lock Speakon connector.
7
1
2
5 00 WAT TS @ 4 OH MS
S P E A K E R
CLA SS 2 W I R I N G
29
28