Gallien-Krueger MB Fusion 800 소유자 매뉴얼 - 페이지 9
{카테고리_이름} Gallien-Krueger MB Fusion 800에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gallien-Krueger MB Fusion 800 12 페이지.
페이지 인쇄
Sound Tips
The MB 500 has several unique features which, if
used properly, will obtain the sound you have been
searching for.
The Equalizer:
The Equalizer is used to fine tune your sound.
When adjusting making adjustments, do it just a
little at a time. These are active circuits and small
changes can make a big difference in your sound.
With a little experimentation you will find that this
equalizer is very easy to use and provides you with
a large variety of great sounds unique to GK.
Contour:
Increasing the Contour level will scoop out
midrange frequencies while boosting the highs and
lows. The sound, once again, is unique to GK and
available on any other Bass amp. Lower contour
settings are recommended for midrange clarity at
higher playing levels.
Boost/Master B:
Turning up the Boost control will add a little growl
to your tone by adding a small amount of ever
order harmonic distortion. This is an unmistakable
GK trade mark sound that you will surely grow to
appreciate. Raising the Boost while lowering
Master B will add more growl while keeping the
sound level the same. You can use Master B to
increase or lower the overall output volume when
switching the Boost on via the front panel or from
the included foot switch. In either normal or boost
mode, the cleanest sound is obtained with Master
Volume settings at 3 o'clock.
Direct Out:
The MB Series provides a low noise, high quality
balanced direct output for connection to PA and
recording consoles. A Ground Lift switch is
MB 500
included to remove hum and buzz when
connecting to equipment powered by a different
ground system.
With the Pre/Post EQ switch set to "Pre" (Out), the
direct output signal is fed directly from the input
stage providing a low noise output superior to
external direct boxes and impedance transformers.
In the "Pre" position, the direct output signal is
only effected by the Input Volume, -10db Pad and
Mute. This allows you to adjust your tone and
volume on stage without changing the Direct
Output signal level and confusing your sound man.
Changing the Pre/Post EQ switch to "Post" ( In),
sends the "GK Sound" (EQ settings etc.) and
preamp response to the Direct Out jack. This gives
you complete control over the Direct Out's tone
and volume.
Limiter:
When this button is engaged it prevents the power
amp from distorting. It is recommended that this
feature
is
used
applications.
9
for
during
high
volume