Gallien-Krueger MB210 소유자 매뉴얼 - 페이지 7
{카테고리_이름} Gallien-Krueger MB210에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gallien-Krueger MB210 10 페이지. Mb series combo amplifier
Gallien-Krueger MB210에 대해서도 마찬가지입니다: 소유자 매뉴얼 (10 페이지), 소유자 매뉴얼 (10 페이지), 소유자 매뉴얼 (9 페이지)
페이지 인쇄
MB112 Control Panel Features
Passive input: A standard 1/4" input to connect
instruments with passive electronics using a
shielded cable.
Active input: A standard 1/4" input to connect
instruments with active or higher output
electronics using a shielded cable.
Gain: Sets the preamp gain after the input stage.
It is used in conjunction with the input pad to
optimize the amplifier's headroom.
Contour: In the on position the button decreases
the mid-range frequencies while boosting low
and high frequencies.
Treble: Boost and cut at 7 kHz shelving type.
Use this control to add or remove edge and
definition.
Hi-Mid: Boost and cut at 1 kHz.
optimized," band pass type works on lower string
harmonics and effects the punch of your sound.
Low-Mid: Boost and cut at 250Hz. A "Q
optimized" band pass type, effects the main body
of your sound.
Bass: Boost and cut at 60Hz, shelving type used
to control the low end push.
Aux In: This 1/8" input for a CD or MP3 player
allows the user to monitor an external audio
source.
Phones: Headphone output. When headphones
are connected, the signal sent to the speaker is
interrupted.
Balanced Direct Out: This electronically
balanced output allows a direct connection to a
P.A. system.
Power Switch: Turns the amplifier on and off. In
the on position, the ring surrounding the button
will light red during power up then changes to
blue, indicating the amp is ready for normal
operation. Should the amp experience a fault
(over heat or over current) the amp will mute and
the ring will light red until the condition is
corrected. This LED turns off when the power is
switched off. This turns the amp off but it does
not completely disconnect the power from the
AC mains.
Rear Panel
AC Receptacle: The detachable power cord
connects here.
A "Q
7