Gallien-Krueger 400RB/115 소유자 매뉴얼 - 페이지 5

{카테고리_이름} Gallien-Krueger 400RB/115에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gallien-Krueger 400RB/115 16 페이지. Artist series
Gallien-Krueger 400RB/115에 대해서도 마찬가지입니다: 소유자 매뉴얼 (16 페이지)

페이지 인쇄

Safety Information

Verify Line, Voltage and Amperage Before

Use:

Your new 400RB-IV Series Bass Amp has been factory

configured for use with:

120 Volt/60Hz 20 Amp circuit for USA & Canada.

230 Volt/50Hz 10 Amp circuit for Europe

. .

& Australia.

100 Volt/50Hz 20 Amp circuit for Japan.

Proper AC circuit for all other countries.

Connecting the amplifier to a line with specifications

other than indicated above can create a safety and fire

hazard, and may damage the amplifier. If you have any

questions about the voltage requirements for your

specific model, or about the line voltage in your area,

contact your dealer before plugging the unit into a wall

outlet.

Verify AC Circuit Capacity Before Use:

The high power output of your amplifier may require

heavy current draw under Full-Load conditions. To

insure proper performance and avoid potential safety

hazards, we recommend connection to line circuits with

Amperage specified "as above". Connecting multiple

amplifiers to the same circuit, or connecting the ampli-

fier to the same circuit used by other heavy-power

devices, such as high-wattage lights, may cause circuit

breakers to trip. It is always a good idea to avoid using

any audio equipment on the same AC circuit as equip-

ment with motors, such as air conditioners or refrigera-

tors. This will lessen to possibility of power variation and

electrical start-up noise affecting your sound.

Warning: Do not disconnect or plug in the instru-

ment/speaker cable with the amplifier power on.

Be sure the amplifier unit is turned off before

connecting to the speaker.

400RB-IV Series

Do Not Use Extension Cords:

To avoid safety hazards, use only the power cord supplied

with your unit. If a replacement cord is used, make

certain that it is of consistent quality and gauge as the

original. We do not recommend using extension cords

with this product. As with all electrical devices, do not

run power cords under rugs or carpets or place heavy

objects on them. Damaged power cords should be

replaced immediately with cords meeting factory specifi-

cations.

Handle The AC Power Cord Gently:

When disconnecting the power cord from an AC outlet,

always pull the plug, never pull the cord. If you do not

intend to use the amplifier for a considerable length of

time, disconnect the plug from the AC outlet.

Mains Disconnect:

If the AC mains has to be completely disconnected, the

plug/power cord is used as the mains disconnect

device and shall remain readily operable.

Do Not Open The Amplifier Enclosure:

There are no user-serviceable components inside this

product. Opening the amplifier enclosure may present a

shock hazard, and modification to the product will void

your warranty. If liquid enters the unit, or any metal

object such as a paper clip, wire, or staple accidentally

falls inside the enclosure, disconnect the unit from the

AC power source immediately and consult an authorized

service station.

Unpacking:

The carton and packing materials used in shipping your

new amplifier were specially designed to cushion it from

the shocks and vibration that occur during transport. We

suggest that you save the carton and packing materials

for use in shipping, in the event you move, or the

amplifier needs repair.