Gallien-Krueger 410RBX-II 소유자 매뉴얼 - 페이지 4
{카테고리_이름} Gallien-Krueger 410RBX-II에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gallien-Krueger 410RBX-II 4 페이지. Bass enclosures
페이지 인쇄
Tech Talk
Impedance Guidelines: The impedance of your speaker
enclosure is referred to as the Ohm rating. Amplifiers
connect cabinets in parallel so when combining speaker
enclosures, the impedance or Ohm rating will go down.
8 Ohms + 8 Ohms = 4 Ohms
4 Ohms + 4 Ohms = 2 Ohms
4 Ohms + 8 Ohms = 2.67 Ohms
Note: If you are combining speaker enclosures of
different impedances, the enclosure with the lower
impedance will receive a greater amount of the signal
causing it to be louder than the other cabinet.
Horn Bi-Amp System:
The RBX cabinets include a passive crossover for standard
operation or may be used with GK's unique Horn Bi-Amp
System.
Horn Bi-Amp compatible amplifi ers use an electronic crossover
to split the signal between the main amplifi er and a separate
horn (tweeter) amplifier. The horn amp sends signals
above 5kHz to the horn while the main amplifi er sends a
full range signal to the woofers. Optionally you can engage
the Woofer High-Cut to to cut signals above 5kHZ from the
main amplifi er. Both signals are delivered to the cabinet via
a single Speakon® cable.
Note: The 50W horn amplifier has a fixed frequency
output of 5kHz and up (high frequencies only). It
will not provide a useable signal to drive a seperate
speaker cabinet.
Note: To avoid risk of damage to the equipment, do
not use a 4-conductor Speakon® cable with non GK
cabinets. Instead use a 2-conductor Speakon® or
¼" speaker cable.
CAUTION:
UNDER NO CIRCUMSTANCES
SHOULD THE WOOFER/MAIN AMP AND
THE 50 WATT HORN AMP BE CONNECTED
TOGETHER!!!
Specifications
410RBX-II
Impedance: 8 ohms
Power Handling (RMS/Program): 400W/800W
Sensitivity: 99 dB
Maximum SPL: 128 dB
Frequency Response (-3dB): 54 Hz to 19 kHz
Useable Low Frequency (-10dB): 31 Hz
Configuration: 4 x 10" 32 ohm woofers plus Horn
Porting: Front Slot-Ported
Dimensions (W x H x D): 23.5" x 26.5" x 18.5"
Weight: 91.5 lbs.
210RBX
Impedance: 8 ohms
Power Handling (RMS/Program): 400W/800W
Sensitivity: 99 dB
Maximum SPL: 125 dB
Frequency Response (-3dB): 63 Hz to 19 kHz
Useable Low Frequency (-10dB): 34 Hz
Configuration: 2 x 10" 16 ohm woofers plus Horn
Porting: Front Slot-Ported
Dimensions (W x H x D): 23.5" x 19.5" x 18.5"
Weight: 54 lbs.
115RBX-II
Impedance: 8 ohms
Power Handling (RMS/Program): 400W/800W
Sensitivity: 101 dB
Maximum SPL: 127 dB
Frequency Response (-3dB): 50 Hz to 19 kHz
Useable Low Frequency (-10dB): 42 Hz
Configuration: 1 x 15" 8 ohm woofer plus Horn
Porting: Front Triangular-Ported
Dimensions (W x H x D): 23.5" x 19.5" x 18.5"
Weight: 54 lbs.
RBX Series Bass Enclosures
Owner's Manual
Part # 160-0450-A1