Copystar FS-2020D 설치 매뉴얼 - 페이지 2
{카테고리_이름} Copystar FS-2020D에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Copystar FS-2020D 2 페이지.
페이지 인쇄4
Adding Paper to the Paper Cassette
The paper cassette can accommodate
A6(FS-2020D model:A5) to A4/Letter
and Legal size paper and can hold
approximately 500 sheets.
4
If you are going to set paper that is
longer than A4/Letter, pull out the
extension paper cassettes pushing the
lock lever one by one and adjust them
to the desired paper size.
8
Set the stack of paper so that it is under
the clips as shown.
5
Connecting Cables
1
Connect the printer to the PC or your network device. Use shielded interface cables.
These cables are sold separately.
Remove the cap, when using the network interface.
Important:
Installing the optional network interface card on the FS-2020D model enables the
network function.
Cap
6
Selecting the Message Language
1
Turn the power switch to on ( | ).
Important:
The printer will begin replenishing the toner; this will take approximately 15
minutes.
Refer to the Operation Guide to set network parameters and to install the printer driver.
© 2008 by KYOCERA MITA Corporation All rights reserved. 2-28, 1-Chome, Tamatsukuri, Chuo-ku, Osaka 540-8585, Japan
1
Pull out the paper cassette.
5
Pull the release lever and slide the
paper stopper to the desired paper
size.
Important:
Do not load more paper than
will fit under the load limit marks (
the paper guides.
2
Turn the paper size dial so that the size
of the paper you are going to use
appears in the paper size window.
6
Fan the paper, then tap it on a level
surface to avoid media jams or skewed
printing.
9
Insert the paper cassette into the slot in
the printer. Push it straight in as far as
) on
it will go.
2
Connect the power cord to the printer
and the other end into a power outlet.
2
Wait until the message display indicates MSG Language. The default message
language is English.
Important:
MSG Language may not appear according to the destination.
3
To change the language, press [ ] or [ ] repeatedly until the message display
shows the desired language.
4
Press [OK]. The message language will be changed.
3
Pull the release lever on the left side
guide and slide to the desired paper
size.
7
Place the paper in the cassette, with
side to be printed downward, so that
the leading edge is aligned against the
paper stopper.
Printed in China 302J056020 Rev.1.0 2008.9