Agrowtek MX1i 사용 설명서 - 페이지 2

{카테고리_이름} Agrowtek MX1i에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Agrowtek MX1i 12 페이지. Intelligent reversing motor controller

Introduction

MX1i intelligent motor controllers are designed to operate reversing gear motors for ridge vents, shade

curtains, roll-up side walls and other similar applications. Models are available for both AC (single phase) and

DC current.

The relays in the MX1i are designed in interlocking circuitry such that it is physically impossible to activate

both the forward and reverse direction at the same time even under conditions of a cpu failure, contact

weld, or other component failure.

Position is controlled in terms of "percent open" (% open) and is based on the amount of time that is re-

quired to operate a motor between a fully closed position and a fully open position. The total amount of

time required to open from a close (or vice-versa) is referred to as the "travel time. " Travel time is set in the

MX1i by the GCX control system on the device configuration page (see configuration.)

The position is stored in the MX1i's local memory every time the travel stops. In the event that an operator

changes the position by using the manual knob on the front of the unit, the position will continue to be

tracked and stored accurately in the MX1i's memory.

The local position (% open) as well as the override knob's selection is transmitted to the GCX control system.

The GCX control system can send a target position to the MX1i, however, if the physical/manual knob is not

in the "Auto" position, the MX1i can not be controlled by the GCX control system.

REVERSE

REV

AUTO

OFF

FORWARD

FWD