HighSecLabs RS20N-3 사용자 설명서 - 페이지 8

{카테고리_이름} HighSecLabs RS20N-3에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. HighSecLabs RS20N-3 15 페이지. Secure 2-port and 4-port multi-domain smart card reader
HighSecLabs RS20N-3에 대해서도 마찬가지입니다: 빠른 구성 매뉴얼 (2 페이지)

페이지 인쇄

SEC TIONS

Table of Contents

oPeRaTIoN

Initial MDR Configuration Steps

Table 02 describes the initial MDR configuration steps.

Action

Action Description

Install Smartcard

verify that the applications, drivers and files of the cryptographic software (CSP) that

applications

corresponds to your selected smart card vendor are installed on all the computers that

you plan to connect to the MDR.

Note: Perform a computer restart in case needed to complete the smartcard application

installation.

Select MDR

operational Mode selection is controlled by a hardware dual in-line package (DIP) switch.

operational Mode

led auto association is the default mode.

In this mode, PIN number 2 is pulled down and other PINs are up.

Note: Read the understanding the MDR operational Mode section for further details.

Turn PC oN

Make sure that all the PCs are turned oN.

Connect MDR to

Connect the MDR to Power

Power

Connect uSb

Connect the MDR uSb cables to the computers. Cable numbers correspond to the

Cables to PCs

numbered MDR buttons.

Insert Smartcard

Insert your smartcard into the MDR reader socket.

into the MDR

Note: Make sure the smartcard chip is facing away from you.

Initial association

Press PC Number button#1 to initialize the MDR on PC#1.

with PC#1

HSL RS20N-3 (MDR102) / RS40N-3 (MDR104) Secure 2/4-Port Multi-Domain Smart Card Reader User Manual

Expected Behavior

1 second beep sound.

all PC association led lights blink once.

all PC Number led lights blink constantly.

1 second beep sound.

all lights are off.

PC Number button#1 light turns oN.

PC association led#1 blinks and then turns oN.

The MDR appears as a smartcard reader under PC#1 device

manager.