Agrowtek MX3i 사용 설명서 - 페이지 2

{카테고리_이름} Agrowtek MX3i에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Agrowtek MX3i 13 페이지. Intelligent reversing motor controller

Introduction

M31i intelligent motor controllers are designed to operate reversing gear motors for ridge vents, shade

curtains, roll-up side walls and other similar applications. The MX3 model is designed to operate 3-phase AC

motors only.

The relays in the MX3i are designed in interlocking circuitry such that it is physically impossible to activate

both the forward and reverse direction at the same time, or to directly short any phases to each other even

under conditions of a cpu failure, contact weld, or other component failure.

Position is controlled in terms of "percent open" (% open) and is based on the amount of time that is re-

quired to operate a motor between a fully closed position and a fully open position. The total amount of

time required to open from a close (or vice-versa) is referred to as the "travel time. " Travel time is set in the

MX3i by the GCX control system on the device confi guration page (see confi guration.)

The position is stored in the MX3i's local memory every time the travel stops. In the event that an operator

changes the position by using the manual knob on the front of the unit, the position will continue to be

tracked and stored accurately in the MX3i's memory.

The local position (% open) as well as the override knob's selection is transmitted to the GCX control system.

The GCX control system can send a target position to the MX3i, however, if the physical/manual knob is not

in the "Auto" position, the MX3i can not be controlled by the GCX control system.

REVERSE

REV

AUTO

OFF

FORWARD

FWD