Agrowtek VX12i 사용 설명서 - 페이지 4

{카테고리_이름} Agrowtek VX12i에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Agrowtek VX12i 15 페이지. Digital irrigation valve controller

Installation Instructions

Disconnected all power sources before servicing or wiring. For continued protection against electric shock ensure the enclo-

sure is properly grounded at the marked chassis ground terminal. Install all electrical equipment and wiring in accordance with

national and local electric codes. For indoor use in dry locations only (0-80% RH non-condensing.) Replace serviceable parts only

Débranchez toutes les sources d'alimentation avant l'entretien ou le câblage. Pour une protection continue contre les chocs électriques assurer

l'enceinte est correctement reliée à la borne de terre du châssis marquée. Installez tous les équipements électriques et le câblage conformément

aux codes électriques nationaux et locaux. Pour une utilisation en intérieur dans des endroits secs seulement (0-80% RH sans condensation.)

Remplacer les pièces réparable seulement avec ceux recommandés par Agrowtek Inc.

Notes:

1. Install with the connections facing down to reduce the risk of water permeating the enclosures.

2. For indoor installation only. Enclosures are not water-proof.

3. Do not place sensor in direct sunlight.

The intelligent interface module is to be securely installed to a vertical wall surface using the four mounting

holes provided in the rear of the enclosure.

1. Remove the front cover panel using caution not to damage the LED light pipes.

2. Locate the relay box and mark the mounting hole locations or use the dimensions below.

3. Pre-drill and install anchors if necessary. Keep dust and debris away from the circuit board.

Ensure all dust and contaminants have been blown out of the enclosure.

Hardware is not provided. Drywall screws are recommended.

Do NOT drill holes into the enclosure or enlarge holes. Metal chips from drills can cause short circuits on the PCB.

DANGER Electrocution Hazard

with those recommended by Agrowtek Inc.

DANGER Risque d'électrocution

5.5"

7.0"

BACK

2.1"