Agrowtek VX8i 사용 설명서 - 페이지 8

{카테고리_이름} Agrowtek VX8i에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Agrowtek VX8i 15 페이지. Digital irrigation valve controller

Output Connections, Other Devices

High current FET (transistor) outputs control DC loads and switch the voltage that is supplied to the unit. The

default power supply is 24Vdc. Lower voltage may be supplied to the board (down to 6Vdc) depending on

the requirements of the devices being driven.

Dimmable Ballast or VFD Controller

Relay or Contactor

(PWM Input)

(DC Coil)

GND

1. Dimmable Ballasts & VFD Motor Controllers

Ballasts and VFD controllers that accept a 1kHz PWM signal may be controlled by the rst six (6) output chan-

nels for variable speed motor control or variable intensity lighting control. Each of the six channels operate

at 1kHz but may be set to 0, 10-90% and 100% duty independently.

Note: A low-pass lter may be constructed to convert PWM to analog voltage. Consult the light manufac-

turer to determine if PWM signals are accepted, or for advice on analog lter construction.

2. Relays & Contactors

DC powered relays, contactors and SSR's may be driven directly by the outputs. Each output is protected for

yback and surge, and is capable of up to 1A continuous current (1A max combined current.)