Galls Street Thunder ST280 설치 및 운영 지침 매뉴얼 - 페이지 4

{카테고리_이름} Galls Street Thunder ST280에 대한 설치 및 운영 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Galls Street Thunder ST280 20 페이지. Siren amplifier & light controller
Galls Street Thunder ST280에 대해서도 마찬가지입니다: 설치 및 운영 지침 매뉴얼 (18 페이지)

Galls Street Thunder ST280 설치 및 운영 지침 매뉴얼
Installer Selectable Options (Jumper Settings)
The ST280 has several options that can be selected during installation. Jumpers on
the printed circuit board, inside the case, allow the installer to select these various
options. These options should be set before installation of the unit.
Park Kill input polarity
Auxiliary input polarity
Two-tone replacement of Thunder tone
Thunder Disable
Slide Switch Pursuit Siren Disable
Speaker (Audible Beep) Disable
8 second timed gun lock release (S4)
After the cover has been removed, find the location of the option jumpers (see the
diagram below).
Park Kill Input Polarity -
The park kill (cutout)
input turns off any siren
tone output when
activated (i.e. vehicle
shifted into park, door
opened, etc.), and
remains off until a control
on the siren is activated
or changed. The wiring
diagram on page 7
shows two connection
examples.
The park kill input is normally activated by connecting the gray wire to positive
voltage. To activate by connecting it to ground (negative) instead, move the
jumper from the "PK-POS" pins to the "PK-NEG" pins.
Cover Removal - Remove the
four Philip head screws
located on the back of the
unit. DO NOT REMOVE THE
SCREWS ON THE FRONT OF THE
UNIT! Slide the top cover off
the front face of the unit.
Take care not to damage the
microphone cord during this
procedure. This cover can be
removed completely from the
siren unit. Carefully slide the
cover over the microphone
and set it aside.
-2-