Galls K9 Partner 사용 설명서 - 페이지 16
{카테고리_이름} Galls K9 Partner에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Galls K9 Partner 20 페이지. Power door opener
페이지 인쇄K9 Partner Power Door Opener System with PowerTouch Remote Control
Trouble Shooting Guide - K9 Partner Door Opener
Symptom
3.0 No power to remote
control receiver
Symptom
4.0 No signal (code)
being transmitted
Symptom
5.0 Poor range 0' to 25'
(pulsating 0' to 25')
Use a digital or analog voltmeter to check power and voltage!
Possible Cause
3.1 Logic ground or
power connection to
receiver has failed
3.2 Chassis ground
connection has failed
Possible Cause
4.1 Battery voltage low
4.2 Transmitter is not
sending a signal
4.3 Transmitter code is
incorrect
4.4 Not all buttons send
a signal when pressed
Possible Cause
5.1 Antenna damaged or
grounded
Do NOT use a test light
Corrective Action
3.1a Check logic ground (black wire) and logic
power (red wire). Use a voltmeter probe when
checking voltage.
3.1b If either ground or power is not present, then
locate failure in wire harness and repair.
3.2a Check chassis ground connection, it should
be clean and tight, no paint on metal, an external
tooth star washer should be present, no rust or dirt
in connection.
3.2b Chassis ground should be located on vehicle
frame.
Corrective Action
4.1 Check battery voltage. Replace battery if
voltage is 11.5 volts or less. (Signal strength is
dependent upon battery voltage.)
4.2 Place probe from voltmeter on battery (+) and
(-) leads. Press any button, voltage should change
by 0.2 to 0.3 volts if a signal is transmitted. Check
both buttons.
4.3a If transmitter is sending a signal and no
signal is being received, re-code transmitter.
4.3b Send back to factory for re-coding.
4.4 If a signal is not transmitted on all buttons,
send back to factory for repair or replacement.
Corrective Action
5.1a Check antenna placement, it should not be
touching any metal or tinted glass.
5.1b It should not be closer than 6' to any motors
or relays.
5.1c If it is coiled, then stretch it out and place
near a window.
5.1d If antenna is cut or damaged, send back to
factory for repair.
5.1e NOTE: Antenna can NOT be shortened or
altered in any way
Manual C840.N2
Page -16-