Dynex DX-CR112 사용자 설명서 - 페이지 7

{카테고리_이름} Dynex DX-CR112에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dynex DX-CR112 11 페이지. Lecteur de cartes mémoire sd/microsd
Dynex DX-CR112에 대해서도 마찬가지입니다: 매뉴얼 (6 페이지), 사용자 설명서 (11 페이지), 자주 묻는 질문 (5 페이지), 빠른 설정 매뉴얼 (2 페이지), (영어) 사용자 가이드 (11 페이지), (프랑스어) 매뉴얼 드 뤼용자 (11 페이지)

6-in-1 Memory Card Reader

Troubleshooting

If memory cards do not appear in My Computer/Computer (Windows operating systems) or

on the desktop (Mac operating systems), check the following:

• Make sure that the memory card is fully inserted into the slot.

• Make sure the card reader is fully connected to your computer. Unplug and reconnect

your card reader.

• Try a different memory card of the same type in the same slot. If a different memory

card works, the original memory card should be replaced.

• Disconnect the your card reader from your PC and shine a flashlight into the empty

card slots. Look to see if any pin inside is bent, then straighten bent pins with the tip of

a mechanical pencil. Replace your memory card reader if a pin has bent so much that it

touches another pin.

If memory cards appear in My Computer/Computer (Windows operating systems) or on the

desktop (Mac operating systems) but errors occur when writing or reading, check the

following:

• Make sure that the memory card is fully inserted into the slot.

• Try a different memory card of the same type in the same slot. If the different memory

card works, the original memory card should be replaced.

• Some cards have a read/write security switch. Make sure that the security switch is set

to Write Enabled.

• Make sure that the amount of data you attempted to store has not exceeded the

capacity of the card.

• Inspect the ends of the memory cards for dirt or material closing a hole. Clean the

contacts with a lint-free cloth and small amounts of isopropyl alcohol.

• If errors persist, replace the memory card.

• Some memory cards are not compatible with XP such as SDXC. Refer to your card

manufacturer to see if your card is compatible with your OS.

If no icon appears when a card is inserted into the reader (MAC OS X), check the following:

• The card may have been formatted in Windows FAT 32 format. Using a PC or digital

device, reformat the card using OS X-compatible FAT or FAT16 format.

If you get an error message during automatic driver installation (Windows operating

systems), check the following:

• Make sure that your card reader is connected to your computer.

• Make sure that only one card reader is connected to your computer. If other card

readers are connected, unplug them before connecting this card reader.