Dynex DX-HDEN20 사용자 설명서 - 페이지 2

{카테고리_이름} Dynex DX-HDEN20에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dynex DX-HDEN20 12 페이지. Warranty (english)
Dynex DX-HDEN20에 대해서도 마찬가지입니다: 매뉴얼 (6 페이지)

페이지 인쇄

1. Installing the Hard Drive

DX-HDEN20-combo.fm Page 2 Monday, July 11, 2005 5:18 PM

USB External Hard Drive

Enclosure

Introduction

This enclosure allows you to build a USB external hard drive. The USB

external hard drive is a portable, compact hard drive that provides a fast

and easy way to add more storage space to your computer. The drive is

Plug & Play, which means you can connect the drive to your computer

while the computer is running.

Contents

Introduction ..................................................................................... 2

System requirements ....................................................................... 2

Components..................................................................................... 2

Installing the hard drive ................................................................... 2

Using the drive ................................................................................. 2

Legal notices .................................................................................... 4

Français ....................................................... 5

Español ........................................................ 8

System requirements

Hardware

• Notebook or desktop computer with a USB 1.0, 1.1, or 2.0 port.

Operating system

• Windows XP, Windows ME, Windows 2000, or Windows 98SE

• Mac OS 8.60 or later

Components

• LED-Indicates power and data access status.

• USB port-Connects to the USB data cable.

• DC jack-Connects to the USB power cable.

• USB data cable-Connects the USB hard drive to a USB port on

your computer.

• USB power cable-Connects the USB hard drive to an additional

USB port on your computer for power.

Installing the hard drive

To install the hard drive into the case:

1 Remove the hard drive case from the package.

2 Remove the front cover, then remove the circuit board from the

case.

3 Plug the hard drive into the IDE connector. Make sure it is firmly

connected.

4 Insert the circuit board with the hard drive into the case.

5 Attach the front cover to the case, then tighten the screws as

shown below.

Screw

Using the drive

Connecting the drive to your computer

To connect the USB hard drive to your computer:

1 Turn on your computer.

2 Plug the USB data cable into the hard drive's USB port and into a

USB port on your computer.

3 Plug the USB power cable into the hard drive's DC jack and into a

different USB port on your computer.

Installing the driver

If your computer uses Windows XP, Windows ME, Windows 2000, or a

Mac OS version above 8.6, you do not need to install a driver.

If you are using Windows 98SE, you must install a USB driver. The driver is

found on the CD that is included with the hard drive.

Introduction

Screw