GALTA BLP 1000 빠른 시작 매뉴얼 - 페이지 5
{카테고리_이름} GALTA BLP 1000에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. GALTA BLP 1000 14 페이지. Battery lift
페이지 인쇄Stabilization Feature
If lift is to be used as a stationary work surface for servicing components, two leveler screws (see Figure 2)
have been added to help stabilize the platform.
When the desired tilt or platform position has been reached, thread both leveler screws inward until they meet
the bottom of the platform and tighten finger-tight only. This provides two extra points of contact for a more
stable platform.
CAUTION: To prevent equipment damage,
• Do not tighten the leveler screws with a wrench or ratchet.
• Do not tilt the platform if the leveler screws are not in their lowest position.
Platform Sliding Extension Feature
When the lift is to be used as a stationary work surface, the sliding platform extension may be used to facilitate
the separation of powertrain components (i.e., engine and transmission). Retract spring plunger and pull on
Table Handle (See Figure 3) to extend sliding platform. Release spring plunger and slide platform extension
until it locks into a stationary position.
Secure components to the platform with bolts and/or straps. Many M10 x 1.5 holes are provided in the platform
top to thread bolts into. CAUTION: To prevent damaging threads in the platform, do not torque bolts
beyond 50 ft. lbs. (68 N•m). Holes in the side edges of the platform are provided for securing straps.
WARNING: To prevent personal injury and/or equipment damage,
● Always secure components to the platform with bolts and/or straps.
● Do not raise or lower lift with platform extended.
● Do not use the Platform Handle (located on the sliding platform) to move the entire lift.
Platform
Handle
Figure 2
Figure 3
Leveler
Screws
M10 x 1.5 holes
to secure
components
Ho
les for
straps
Spring
Plunger
Sheet 3 of 7